XorMon supports REST API for collecting storage configuration data.
REST API replaces Hitachi CCI (raidcom commands) and SNMP protocol.
Therefore you no longer have to install CCI to XorMon appliance.
Refere to install manuall how to configure it.
Supported storage systems
The REST API supports the following storage systems.
Storage system
Supported firmware version
VSP Gx00 models
For VSP G350, G370, G700, G900 88-01-0X-XX/XX or later For VSP G200, G400, G600, G800 83-01-21-XX/XX or later
VSP G1000
80-01-21-XX/XX or later
VSP G1500
80-05-XX-XX/XX or later
VSP Fx00 models
For VSP F350, F370, F700, F900 88-01-0X-XX/XX or later For VSP F400, F600, F800 83-02-01-XX/XX or later
VSP F1500
80-05-XX-XX/XX or later
VSP N400, N600, N800 (1)
83-06-03-XX/XX or later
VSP E590, E790, E990
93-01-0X or later
Virtual Storage Platform
70-03-01-XX/XX or later
Unified Storage VM
73-01-07-XX/XX or later
(1) Support only for VSP N block controllers
Make sure REST API is installed and configured properly for your VSP storage systems.
Check Hitachi docu ➡ Get started
CCI still has to be used for older models where REST API is not available. (actually not supported in XorMon, use our older tool STOR2RRD instead)
Exclusions
REST API does not support GAD statistics, it would require admin storage rights
Older firmware levels do not support FMC capacity statistics
Known issues
G400 have an issue on 83-05-39, it works fine with 83-05-40